The SW Inverter/Charger is our most popular off-grid power
solution. Available in 24- and 48-volt models, it provides
utility-grade output power and offers high surge capacity to
run most household appliances. The SW offers many
programmable features including automatic generator start
and stop as well as automatic load sensing. Its built-in,
fully automatic, three-stage battery charger is designed to
bring maximum charge to batteries, while using minimum
generator run time and fuel.
Grid Tie: Using the Xantrex Grid Tie Interface (GTI), the SW
converts energy from multiple renewable energy sources,
such as solar, wind, and microhydro, into AC power, selling
power you don't use back to the utility. Software/hardware
revision 4.2 or higher is required to connect the SW4024,
SW4048, or SW5548 to the GTI.
Features:
* Available in 4000 and 5500 watt models
* Utility grade, sine wave power
* Durable construction for long life under extreme
environmental conditions
* Three-stage battery charging (bulk, absorption, and
float) and battery equalization with remote temperature
sensor for increased performance
* Programmable control module with LCD display and LED
indicators
* Low idle current (less than 1 watt) conserves energy when
no loads are present
* Soft start capability for starting heavy loads
* Built in starting control circuits for two- and
three-wire generator starting systems
Expandable and Flexible:
* Parallel stacking capability for more power at the same
voltage (optional equipment is required)
* Three phase configurations available in a Power Module
System for industrial quality power in remote locations
(optional equipment is required; only available on
48-volt models)
